Supports two short parallel wooden slats with each other. This will create the basis Holder wine glasses on hanging wine rack. Mark sections 1.5 inches (3.81 cm) apart with each other in each strip your pencil to have seven sections in each batten. Put the longest wood slats marked above, leaving open between each section. You should have four slats with three openings. Pilot holes drilled in the center of each of the ends of the long strips and the base. Screw each upper bar in place using screws wood.
Put one of your glasses of hanging wine rack in the internal space of the two outer sections empty. Is superimposed on both sides where the timber rests. Trace the outline of the cup on wood. Do the same for the middle section, only at the other end. Cut the holes marked with your saw, cutting about 1/4 inch (0.635 cm) larger in each of the three circles marked.
Three holes drilled through the ends of the wine rack, two on the outer edge and one in the middle. Hold the shelf in place beneath the cabinet and mark the location of the three holes. Drill holes through the base of your cabinet and install hanging wine rack using the butterfly nut bolts.