Dentil molding is often projects like carpentry finishing touches. It is usually 3/8-inch thick and 1/2-inch wide by 3/4-inch long teeth that give the name. It can be purchased in any kind of wood. It can be stained and lacquered wood as any. Also it makes soft wood or composite material and then painted.
Attach the dentil molding of teeth in a place where it should be installed. Store it in terms of market and hold. Note that the ends of the molding are completed. Slide the tape back and forth and swing molding balancing. Mark the ends of the molding in the miter saw to cut the molding leaving equal portions of a single tooth on both ends.
Cut marks on the machine gun on the left and right. Keep the molding to install and check your measurement. Attach the molding where you want to install. Keep it tight and nailing pin through it, every 8-inch. Collect two pieces of molding and examine sealing the ends.
Finally, to install dentil molding, cut the miter teeth left and right hand marks. Cut to length and install hammer nails through the molding. Continue around the project of cutting tooth form accordingly to preserve the model teeth.